How do I fix F06 error on Whirlpool washer?
How do I fix F06 error on Whirlpool washer?
How to Fix F06 on a Whirlpool Duet
- Touch “Pause/Cancel” twice to cancel the F06 error on the display.
- Plug the power cord back in and select a new wash cycle.
- Press “Pause/Cancel” twice again if the F06 error code resumes.
What does F06 mean on my Whirlpool washing machine?
drive motor tachometer error
Whirlpool , Washers. 4 Answers from these members: The “F06” fault code indicates a drive motor tachometer error. This means the control is unable to properly detect motor speed and the machine will shut down. If the failure occurs during high-speed spin, the door will unlock after 3 minutes.
How do you reset a Whirlpool washing machine?
The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
How do I fix Indesit F06 error?
Indesit error F06 The door won’t close properly: Check if there’s any laundry in the door. Put the laundry all the way in the drum. Close the door and restart the washing machine.
How do I fix Hotpoint F06 error?
When your Hotpoint washer dryer shows error message F06, you will need to check the door area for any obstructions. Closely inspect the door lock and surrounding areas, removing anything in its way. Once you have cleared any obstructions, try to restart the machine programme.
What does F06 mean on a battery charger?
Digital Battery Charger Error Code Explanation Chart
| Error Code | Description |
|---|---|
| F04 | The connections to the battery are reversed. |
| F05 | The charger was unable to keep the battery fully charged in maintain mode. |
| F06 | The charger detected that the battery may be getting too hot (thermal runaway). |
How do I fix f15 error?
This error is almost always caused by a failed motor control unit. Check the wiring between the central control unit and the motor control unit and motor for loose connections or damaged wires. Check the drive belt. If all this looks ok then replace the motor control unit (MCU).
