How do you remove metal toilet seat bolts?

Published by Charlie Davidson on

How do you remove metal toilet seat bolts?

Use a deep well socket to reach the nut on the underside of the toilet and attempt to loosen it. Use a Dremel tool with a cutting blade to cut through the bolt and nut. Use an oscillating tool to cut through the bolt and nut. Tape off the area around the bolts and cut the tops off the bolts using a mini hacksaw.

How do you remove a metal hinge from a toilet seat?

The metal bolts are part of the toilet seat hinge hardware. Simply unscrew the nut from the attached bolt. Corroded bolts and nuts are harder to detach. To remove the nut from the seat hinge bolt, use a long socket and socket wrench to unscrew the nut.

How do you remove old rusted bolts?

Hydrogen peroxide can dissolve rust. Applying hydrogen peroxide to the fasteners and letting it sit is also an effective method to remove rust and loosen nuts and bolts. Scouring it with a hard brush will help you get rid of all the rust left on the nuts and bolts.

How do you remove a toilet seat without screws?

In a situation where the hardware of your toilet seat proves resistant to the screwdriver, you can bring in the hacksaw. Use a wide knife such as the putty knife and place it so that it can cover the porcelain that is around the bolt head. This is for the prevention of accidental scratches as you saw.

Can you replace toilet seat hinges?

They serve to raise and lower the seat. Over time, these hinges break or wear out, requiring replacement. If your toilet seat hinges are broken, you do not need to change the whole toilet seat, only the hinges. With the right tools and spare parts, you can easily replace your toilet seat hinges.

Can Coke loosen a rusted bolt?

Coke, also known as Coca-Cola, is a soft drink. But a few of its ingredients are acids, which make it useful for removing rust. Acids such as phosphoric acid, hydrochloric acid or oxalic acid are found in most commercial rust removers. This means that Coke helps to get the rust of screws.

How do you remove plastic toilet seat screws?

If the bolts or nuts are plastic, they can’t corrode and will come off easily. Simply pry open the cover behind the seat to expose the bolt’s head. Unscrew the bolt with a pliers or a screwdriver while you hold the nut underneath with the pliers.

How to remove and replace a toilet seat?

Carefully work through the caps with your flat head screwdriver to remove them. After removing the caps, you can now see the top side of the bolt that is holding the seat in place. Under the toilet, you will find bolts that stick out. These bolts are tightened by wingnuts.

What to use to remove nuts from toilet seat?

The locking pliers strategy usually works in this situation as well as it does when the bolts are plastic, but instead of using soapy water, Arco Plumbing suggests lubricating the bolts with spray lubricant.

Can you use pliers to unscrew a toilet seat?

If the bolts securing the seats are made of metal, you could use a pair of pliers to unscrew them. But metal hinges have one disadvantage, they rust. This means that even the pliers may be unable to unscrew the bolt.

What’s the best way to remove hinges from a toilet seat?

Use a drill to pierce through the metal hinges. The drill will exert a lot of force, breaking the metal hinge apart. Use a propane torch to loosen the bolts then break the pieces of metal down to remove them. Set it at a low flame and be very cautious to avoid burns.

Categories: Contributing