How do I get rid of the trouble light on my DSC alarm?

Published by Charlie Davidson on

How do I get rid of the trouble light on my DSC alarm?

DSC Security System Trouble Light When a trouble is present the system trouble indicator light will illuminate and the keypad will beep every 10 seconds. To silence the trouble beep simply press the # key on the keypad. Now press *2 on your security keypad.

What does it mean when your alarm system says trouble?

A trouble signal (sometimes indicated in the alarm history by the abbreviation TR) indicates a possible problem or difficulty with your security system, such as a loose wire, a poorly aligned sensor or a low battery status.

What does the yellow triangle on my alarm mean?

trouble condition
The yellow triangle means that your alarm system is experiencing a trouble condition. This could be caused by a number of different possible factors, such as a low battery, an activated tamper or communication problems.

How do you clear the yellow light on a DSC alarm?

Press the ‘7’ key and you will receive a number corresponding to the affected zone. The indicated zone is reading a low battery condition and needs a replacement battery. Replace the battery in the contact and the condition will clear.

How do I reset my alarm keypad?

You can reset your alarm system by powering it down and then powering it back on. This is what is known as a power reset. To power down the system, the backup battery must be disconnected, and the transformer must be unplugged. Then reconnect the battery and transformer to power it back on.

How do I clear the fault on my ADT alarm?

How to reset an ADT alarm system

  1. Read the keypad manual to find the reset code;
  2. Enter the reset code and wait for the system reboot;
  3. Enter your security code to arm the alarm;
  4. Disarm the alarm.

How do I disarm alarm without code?

If you know the code to disarm the alarm, enter it and see if that stops the beeping sound. If you don’t know the code, look for buttons labeled “clear” or “reset” and press those. Note: You can also try pressing the “*” or “#” keys, as these buttons often silence the keypad sounder.

What causes a lit trouble light on my alarm system?

While the the possible causes of a lit trouble light are endless, the most probable cause and solutions are outlined here: Normal control panel battery life is 2-5 years. Replace the battery in the control panel. Control panel outage, power outage to the house, loss of power to plug, transformer for the system is dead.

What should I do if my shield alarm is not working?

(Have your recently lost or changed phone service?) To clear “Com Fail” message, call our office and have us put your system on “test.” Then, arm the system and open a device on your system (eg. window). Let the system go into alarm (actually making the siren sound).

How can I Clear Com fail on my alarm system?

To clear “Com Fail” message, call our office and have us put your system on “test.” Then, arm the system and open a device on your system (eg. window). Let the system go into alarm (actually making the siren sound). At this point, the system will send a signal to the central station and clear your communication failure.

Why does my DSC alarm keep going off?

DSC alarms can go off for a number of reasons. To reset the alarm or the warning lights, enter your master code twice, press the reset button, and then enter “*72” if the alarm is still ringing.

Categories: Trending