Can I connect 2 switches to my router?

Published by Charlie Davidson on

Can I connect 2 switches to my router?

Theoretically, the number of network switches that can be connected to a router is infinite. A process known as daisy-chaining allows you to connect as many switches together as you wish, however, this is not recommended as it does come with the risk of creating a loop if they are not connected correctly.

Can one network have two switches?

VLANs allows us to take a single physical switch and logically group ports into multiple smaller switches. Each smaller group would be a VLAN. This is no the only configuration though. A single VLAN can also span multiple switches to regroup ports from multiple switches to work as a single switch.

What is layer3 switching?

A Layer 3 switch is basically a switch that can perform routing functions in addition to switching. A client computer requires a default gateway for layer 3 connectivity to remote subnets.

Which are the 2 trunking protocols?

Trunking Protocol Standards. There are two trunking protocols used on modern communication networks: Inter-Switch Link (ISL) from Cisco and the aforementioned nonproprietary IEEE 802.1Q. Of the two, IEEE 802.1Q is the industry standard. Even Cisco switches now use IEEE 802.1Q (dot1q) by default.

How many routers can you daisy chain?

Daisy chain routers are two or more routers connected to each other where each router between the ends is connected to exactly two other routers, with the terminal routers connected to only one router. In a linear topology network, there is a two-way link between one node and the next.

Do switches have multiple IP addresses?

Unmanaged and layer 2 network switches do not have an IP address, whereas managed switches and layer 3 switches do. A network switch with an IP address is required for Telnet which allows remote access to the switch. The IP address of a switch can be found via the router or an IP scanner.

Can a switch port have multiple VLANs?

It is possible. You can have three vlans on one port if the switch configuration allows it. Mine allows one for data and one for VoIP. The quick answer is yes, That’s called a trunk.

DO network switches increase latency?

If they are right next to each other, each switch should not add much latency since they generally forward frames immediately without them getting stuck in large buffers. Latency is subjective, for a high speed trading firm, 2ms could make a huge difference. For most of us 2ms is not enough to worry about.

How to connect 2901 router to 2 switches?

I have connected 2901 router to 2 switches (2960). Vlan 10 is configured in switch 1 and Vlan 20 is configured in switch 2. Ip address of host in switch 1 is 192.168.1.10 and ip address of host in switch 2 is 192.168.2.10. I need to communicate between the 2 hosts. But Its not communicating.

How to configure two switches and a router?

I assume the trunk (fa0/1) switch interfaces are connected to the router – if that’s the case, you’ve got an “access vs. trunk” mismatch between the switches and the router: either change fa0/1s to access mode, or define sub-interfaces gi0/0.10 and gi0/1.20 on the router and move its .1 IPs there. 08-02-2016 04:38 AM 08-02-2016 04:38 AM

What is the IP address of switch 1?

Vlan 10 is configured in switch 1 and Vlan 20 is configured in switch 2. Ip address of host in switch 1 is 192.168.1.10 and ip address of host in switch 2 is 192.168.2.10. I need to communicate between the 2 hosts.

Categories: Trending