How do I find the interface configuration on an HP switch?

To check the mode setting for a port on the switch, use either the Port Status screen in the menu interface or show interfaces brief in the CLI (see Viewing port status and configuration (CLI)).

How do I find the IP address of my HP switch?

A switch should have a web interface and a telnet interface. Another approach would be to use the arp command to find its IP address from the Mac address (which should be physically labeled on it somewhere).

How do I configure my HP 1920 switch?

Initial configuration

1. Place the switch close to the PC that will use for configuration.
2. Connect power to the switch, and then start the PC (If it is not already running) and wait until the switch and PC have finished their start-up sequences.
3. Connect the PC to any port on the switch using a standard Ethernet LAN cable.

How do I manage my HP switch?

How to: Configure a HP ProCurve switch

1. Step 1: Connect your serial connection.
2. Step 2: Conenct PuTTY.
3. Step 3: Get the IP address.
4. Step 4: Set time server.
5. Step 5: Set SNMP community info.
6. Step 6: Launch the web GUI.
7. Step 7: Configure basic info.
8. Step 8: Create VLANs.

How can I find switch configuration?

How to configure Cisco switch?

1. Initial command prompt “Switch>” appears on the screen.
2. Type “enable” next to it and press “Enter”.
3. This will take you into the “EXEC” mode, also known as the Global Configuration mode.
4. Go into configure mode using configure terminal.
5. Enter the configuration commands one per line.

Which command is used to enable an interface?

no shutdown command
To enable an interface, it must be activated using the no shutdown command. (This is similar to powering on the interface.) The interface must also be connected to another device (a hub, a switch, or another router) for the physical layer to be active.

How do I find the IP address of my network switch?

1. Select the Wi-Fi network icon on the taskbar and then “Network settings”.
2. Select “Wi-Fi”.
3. Select “Advanced options”, located towards the bottom-right.
4. Under Properties, look for your IP address listed next to “IPv4 address”.

How do I reset my HP 1920 switch?

To execute the factory default reset on the switch, perform these steps:

1. Using a small, thin tool with blunt ends (such as a paper clip), press the Reset button on the front of the switch.
2. Continue to press the Reset button until the Fault LED light begins to flash.
3. Release the Reset button.

How do I access my HP 1810 switch?

Open the web browser on the PC, and enter the switch factory-default address, http://192.168.2.10, to access the switch’s web interface. Click Log on to log onto the switch (by default, there is no password).