How do I access my Linksys WAP300N?

Published by Charlie Davidson on

How do I access my Linksys WAP300N?

  1. To install your WAP300N: Insert the CD into your CD or DVD drive Make sure that the computer is.
  2. already connected to your home network. Click Set up your wireless access point.
  3. Setup icon. Follow the on-screen instructions.

What is the default IP address for Linksys WAP300N?

10.100.1.1
Access the Linksys WAP300N’s web-based setup page by opening a web browser and entering its IP Address on the Address bar. NOTE: The default IP Address of the Linksys WAP300N is 10.100. 1.1.

What is Linksys WAP300N?

The Linksys WAP300N is a dual-band Wireless-N Access Point that can be configured to work as a range extender. This functionality of the device will allow you to extend the range of your existing wireless network and eliminate dead spots in the area.

How do I reset my Linksys WAP300N?

Hold the Reset button at the back panel of the WAP300N for about 10 seconds then release. You can also use the web interface to reset the access point. To do this, go to the Administration tab > Factory Defaults then set Restore Factory Defaults to Yes and click Save Settings.

How do I configure my Linksys WAP300N router?

Setting the Linksys WAP300N to Wireless Range Extender mode

  1. On the Setup page, click the Operation Mode sub-tab.
  2. Click Wireless Range Extender, then click Save Settings.
  3. Wait for the Operation Mode change progress bar to finish.
  4. You will be directed to the Setup page once the change is applied.

How do I setup my Linksys n300 wifi range extender?

Extend your Internet access in 3 easy steps:

  1. Connect the power cable.
  2. Plug in the range extender midway between your router and the area without Wi-Fi.
  3. Once a solid light appears on the range extender cover, connect to the Wi-Fi network “Linksys Extender Setup.”

Categories: Helpful tips